Hey, my Name is Erik and this is what I do. Over the last years I have learned quite a lot reading topics at the london lounge.
I use CAD to develop pattern and detailed customer profiles -( no MTM Software ! just real and simple Vector Software ).
On the other hand I am a Craftsmen, continuously discovering the beauty of tailoring and learnig further on....astounding styles in this fine forum.
I am not always online. So If there are any questions regarding CAD supported bespoke development it may take some time to answer...
This picture shows me in a handcrafted and moulded suit with matched stripes beside the CAD Profile.
sincerely Erik
Erik - short Introduction - new member
Welcome. You forgot to tell your CAD programme about the pocket flaps. It's a shame these computer softwares can't think for themselves.
-
- Posts: 94
- Joined: Sat Dec 20, 2008 12:00 am
- Location: Memphis,Tn/Chester UK
- Contact:
Welcome
Yes your right shredder.... Well you never get perfect....shredder wrote:Welcome. You forgot to tell your CAD programme about the pocket flaps. It's a shame these computer softwares can't think for themselves.
-
- Information
-
Who is online
Users browsing this forum: No registered users and 66 guests